Two Fundamental Health Procedures For
The Health Recovery Plan
1. Brushing Your Teeth
Almost all diseases are influenced to a large or small extent by the condition of the mouth and the teeth, therefore all protocols listed in this MMS Health Recovery Guidebook should be accompanied by a daily brushing of one’s teeth with MMS1. It has been shown time and again that MMS1 can restore health to the mouth and in the case of doing these protocols, better results are often noticed when brushing with MMS1, even when the teeth and mouth are in very bad shape.
This does not mean that one will not need the services of a good dentist, but once the infections and diseases of the mouth are gone then the dentist can do a much better job, and the diseases of the body are 10 times more likely to be overcome. Thus a preliminary step to this recovery plan is to buy a good soft tooth brush for brushing teeth and gums while at the same time doing the protocols.
If you use a toothbrush with toothpaste some of the time, keep a separate toothbrush that you use only with MMS1 (and DMSO if you use it). This will help avoid toothpaste residue left on the toothbrush mixing in with the MMS1. Under no circumstances should you ever use toothpaste which contains fluoride.
Brushing Teeth Procedure
Step 1
Step 2
Note: For a number of years, people around the world have been successfully using MMS1 to keep their mouths in shape and to overcome various teeth and gum infections. You don’t have to worry about the alkalinity of the sodium chlorite nor the acidity of MMS1 leaching mercury out of your teeth. This is because the acidity in the MMS activator when mixed drop for drop with the MMS (sodium chlorite) which is alkaline, is calculated to mostly cancel one another out, leaving the MMS1 solution much closer to neutral.
The acidity is then much less than most fruits and cannot hurt your teeth or leach mercury from your fillings. Keep in mind that fruits and vegetables are acidic in nature more so than MMS1 doses. (For more information on the acidity and alkalinity of fruits and vegetables, see Appendix C.)
DMSO and Teeth
If your teeth are in poor shape, for example if you have an abscess, pain, or more serious complications with your teeth, add DMSO to your teeth brushing routine. DMSO will carry the MMS right through the enamel into the tooth and can help solve many problems.
Step 1
Step 2
Tip: If you want to use the same solution described in the Brushing Teeth Procedure for more than one brushing, you will need to put the solution in a bottle with a tight lid. If you want to dip your toothbrush into the liquid, it is no longer reusable. So if you want to “dip” do not contaminate your entire mixture. Instead, pour part of the solution into a small glass and proceed with dipping your tooth brush into that liquid 3 or 4 times while brushing, then discard any leftover “dipping” solution.
Double the amount of activated drops of MMS to 1/2 cup [4 ounces/120 ml] of water) to make up a portion for the day. If you make up this solution for the day, you cannot add DMSO. DMSO must be added immediately before use, as over time, it will weaken your MMS solution.
2. Spraying Your Skin
While on this Health Recovery Plan, if you have any kind of skin problems, be it skin cancer, eczema, psoriasis, infections or wounds, etc., spraying the skin or wound with MMS is a great help. I have listed this protocol in the fundamental steps for the HRP (Health Recovery Plan), because it is important for skin problems to start right away with spraying the skin as you begin your health recovery. Using this spray bottle is also helpful for most any type of isolated skin problems as well, such as wounds or bruises, to help the overall condition of the skin, and many more conditions. It can be used for the rest of your life for skin problems, whether you are on the other protocols or not. Anytime the MMS spray stings or burns your skin go to the Mold/Fungus Protocol and check the section on the mold/fungus external procedure (see page 106 of the manual).
MMS1 Spray Bottle
Tip: You can spray a little on your face and then spray or pat a little DMSO (dimethyl sulfoxide, see Chapter 4) on top. Rub your face lightly to help ease wrinkles. DMSO often makes the MMS spray more effective anywhere on the body. When spraying both MMS1 or DMSO on your face, avoid getting it in your eyes.
Variation:
If you do not see results with the 10-to-1 MMS1 spray bottle, you can increase the strength of your spray solution up to as many as 50 activated drops of MMS per 1 ounce/30 ml of water. Always begin with 10 activated drops (MMS1) per 1 ounce/30 ml, and increase the drops in increments to see what works best for you. Anytime the MMS1 spray solution stings and/or burns, regardless of how weak or strong it is, it most likely is an indication that some type of fungus is present. In this case, rinse it off with purified water and apply the clay and Vaseline salve described in the Mold/Fungus Protocol (pages 106-107 of the manual).
MMS2 Spray Bottle
We have received feedback from many people who have used MMS2 in a spray bottle with positive results for the skin. Both MMS1 and MMS2 help the skin in varying ways, so try them both, and see what works best for you. Please note, in the directions below there are some differences in the use of MMS2 and MMS1 when used in a spray bottle.
Note: Unlike the MMS1 spray bottle, do not use an MMS2 spray bottle with DMSO as this could cause a burn.
Almost all diseases are influenced to a large or small extent by the condition of the mouth and the teeth, therefore all protocols listed in this MMS Health Recovery Guidebook should be accompanied by a daily brushing of one’s teeth with MMS1. It has been shown time and again that MMS1 can restore health to the mouth and in the case of doing these protocols, better results are often noticed when brushing with MMS1, even when the teeth and mouth are in very bad shape.
This does not mean that one will not need the services of a good dentist, but once the infections and diseases of the mouth are gone then the dentist can do a much better job, and the diseases of the body are 10 times more likely to be overcome. Thus a preliminary step to this recovery plan is to buy a good soft tooth brush for brushing teeth and gums while at the same time doing the protocols.
If you use a toothbrush with toothpaste some of the time, keep a separate toothbrush that you use only with MMS1 (and DMSO if you use it). This will help avoid toothpaste residue left on the toothbrush mixing in with the MMS1. Under no circumstances should you ever use toothpaste which contains fluoride.
Brushing Teeth Procedure
Step 1
- In a glass activate 5 drops of MMS.
- After 30 seconds add only 1/4 cup (2 ounces/60 ml) of water to the MMS1 drops.
Step 2
- Brush both your gums and your teeth with this mixture for at least two minutes. (Pour some of the liquid over the toothbrush 3 or 4 times while brushing. See tip on page 75 of the manual.)
- Do this 2 or 3 times a day while doing the protocols in the manual.
Note: For a number of years, people around the world have been successfully using MMS1 to keep their mouths in shape and to overcome various teeth and gum infections. You don’t have to worry about the alkalinity of the sodium chlorite nor the acidity of MMS1 leaching mercury out of your teeth. This is because the acidity in the MMS activator when mixed drop for drop with the MMS (sodium chlorite) which is alkaline, is calculated to mostly cancel one another out, leaving the MMS1 solution much closer to neutral.
The acidity is then much less than most fruits and cannot hurt your teeth or leach mercury from your fillings. Keep in mind that fruits and vegetables are acidic in nature more so than MMS1 doses. (For more information on the acidity and alkalinity of fruits and vegetables, see Appendix C.)
DMSO and Teeth
If your teeth are in poor shape, for example if you have an abscess, pain, or more serious complications with your teeth, add DMSO to your teeth brushing routine. DMSO will carry the MMS right through the enamel into the tooth and can help solve many problems.
Step 1
- Mix up the MMS1 teeth brushing mixture described above.
- Brush your teeth with this mixture for a minute or so. This is for an initial cleansing of the mouth and teeth and to clear out anything you do not want DMSO to “carry” deeper into the tissues and enamel of your teeth.
- After this initial cleanse, rinse your mouth well.
Step 2
- Next, add DMSO to the rest of the MMS1 mixture and continue brushing with DMSO added. You must add DMSO to your mixture immediately before continuing to brush.
- Add 3 drops of DMSO for each 1 drop of MMS that you are using. For the formula above, this would be 15 drops.
- If you have DMSO that is already diluted some, use 4 drops for each MMS drop.
Tip: If you want to use the same solution described in the Brushing Teeth Procedure for more than one brushing, you will need to put the solution in a bottle with a tight lid. If you want to dip your toothbrush into the liquid, it is no longer reusable. So if you want to “dip” do not contaminate your entire mixture. Instead, pour part of the solution into a small glass and proceed with dipping your tooth brush into that liquid 3 or 4 times while brushing, then discard any leftover “dipping” solution.
Double the amount of activated drops of MMS to 1/2 cup [4 ounces/120 ml] of water) to make up a portion for the day. If you make up this solution for the day, you cannot add DMSO. DMSO must be added immediately before use, as over time, it will weaken your MMS solution.
2. Spraying Your Skin
While on this Health Recovery Plan, if you have any kind of skin problems, be it skin cancer, eczema, psoriasis, infections or wounds, etc., spraying the skin or wound with MMS is a great help. I have listed this protocol in the fundamental steps for the HRP (Health Recovery Plan), because it is important for skin problems to start right away with spraying the skin as you begin your health recovery. Using this spray bottle is also helpful for most any type of isolated skin problems as well, such as wounds or bruises, to help the overall condition of the skin, and many more conditions. It can be used for the rest of your life for skin problems, whether you are on the other protocols or not. Anytime the MMS spray stings or burns your skin go to the Mold/Fungus Protocol and check the section on the mold/fungus external procedure (see page 106 of the manual).
MMS1 Spray Bottle
- The standard spray bottle formula is 10 to 1. That is, 10 activated drops of MMS to 1 ounce/30 ml of water.
- Never use tap water for any MMS mixture as it is not safe to risk getting chlorine, fluoride, or other impurities in the solution. Use only bottled drinking water, reverse osmosis, or distilled water.
- In most places 2-ounce or 4-ounce size spray bottles are available at the pharmacy or in health food stores. Simply multiply the formula, 20 drops MMS1 to 2 ounces of water, or 40 drops of MMS1 to 4 ounces of water.
- In general this mixture will last up to a week or so. You will know that it lost its potency when the original color begins to noticeably fade. q Do not leave your spray bottle in the sunlight; storing it in a dark place will help the MMS1 solution to remain strong.
- Use this for spraying all problems on your skin.
- When using an MMS1 spray bottle on your face, avoid getting it in your eyes.
Tip: You can spray a little on your face and then spray or pat a little DMSO (dimethyl sulfoxide, see Chapter 4) on top. Rub your face lightly to help ease wrinkles. DMSO often makes the MMS spray more effective anywhere on the body. When spraying both MMS1 or DMSO on your face, avoid getting it in your eyes.
Variation:
If you do not see results with the 10-to-1 MMS1 spray bottle, you can increase the strength of your spray solution up to as many as 50 activated drops of MMS per 1 ounce/30 ml of water. Always begin with 10 activated drops (MMS1) per 1 ounce/30 ml, and increase the drops in increments to see what works best for you. Anytime the MMS1 spray solution stings and/or burns, regardless of how weak or strong it is, it most likely is an indication that some type of fungus is present. In this case, rinse it off with purified water and apply the clay and Vaseline salve described in the Mold/Fungus Protocol (pages 106-107 of the manual).
MMS2 Spray Bottle
We have received feedback from many people who have used MMS2 in a spray bottle with positive results for the skin. Both MMS1 and MMS2 help the skin in varying ways, so try them both, and see what works best for you. Please note, in the directions below there are some differences in the use of MMS2 and MMS1 when used in a spray bottle.
- Add enough MMS2 powder (calcium hypochlorite) to a clean, dry spray bottle (a 2 ounce/60 ml or 4 ounce/120 ml size bottle works well) to just cover the bottom of the bottle.
- Fill the rest of the bottle with purified, distilled or reverse osmosis water.
- Shake it well to dissolve the MMS2 powder.
- Then put the MMS2 solution through a clean paper coffee filter into a clean dry glass. (If possible, use unbleached brown paper coffee filters.) MMS2 usually has small lumps that do not easily dissolve and if not strained out it will clog your spray bottle.
- Before putting the MMS2 solution back into the spray bottle, be sure to rinse the bottle out well with clean purified water, to be sure there are no lumps that will clog up your sprayer.
- When using an MMS2 spray bottle on your face, avoid getting it in your eyes.
Note: Unlike the MMS1 spray bottle, do not use an MMS2 spray bottle with DMSO as this could cause a burn.